Home/Hobbies/Resin Print Cost Calculator

Hobbies

Resin print cost calculator

Resin math has one extra step filament doesn't: slicers report volume, but resin is sold by weight, and density is the bridge. This resin cost calculator takes your model's volume, applies a density of about 1.05–1.12 g/ml for standard resins, adds the 10–30% that supports typically consume, and prices the print against your bottle — a 40 ml mini lands near 51 grams and about $1.95 on a $35 bottle, with roughly 19 prints to the kilogram. The failure allowance is there because failed exposures waste resin and time the same way spaghetti prints waste filament. The note carries the part that isn't optional: uncured resin needs nitrile gloves and ventilation, every time.

Live calculator

Enter your details

Updates instantly
CCALCFORGED
Hobbies / Calculation sheet

Resin Print Cost Calculator

Price a resin print from slicer volume, supports, and bottle cost.

Inputs used

Model volume40 ml
Resin density1.1 g/ml
Bottle size1000 g
Bottle price35 $
Support allowance15 %
Failure allowance10 %

Results

Resin per printEstimate50.6 g
Resin cost per printEstimate$1.95
Prints per bottleEstimate19 prints
Safety & extrasWash-and-cure consumables (IPA, filters, FEP film) add a little per print. Uncured resin is safe for nobody's skin: nitrile gloves, ventilation, and no bare-hand handling until it's cured.

Additional notes

CalcForgedPractical calculators. Straight answers.

Your estimate

Results

Planning estimate
Resin per printEST.50.6 g
Resin cost per printEST.$1.95
Prints per bottleEST.19 prints
Safety & extrasWash-and-cure consumables (IPA, filters, FEP film) add a little per print. Uncured resin is safe for nobody's skin: nitrile gloves, ventilation, and no bare-hand handling until it's cured.

The math, plainly

How it works

  1. 01

    Slicer volume converts to grams through the resin's density — standard resins run about 1.05–1.12 g/ml — then the support allowance adds its share.

  2. 02

    Cost per print is grams times price per gram, inflated by the failure allowance the way failed exposures eat resin and time.

  3. 03

    Prints per bottle divides bottle size by per-print grams and rounds down — the bottom of the bottle always stays dirty.

Try a real scenario

40 ml mini on a $35 bottle

Inputs40 ml model, 1.1 g/ml density, 15% supports, 10% failures

ResultAbout 51 g of resin per print — $1.95 each, roughly 19 minis per 1 kg bottle.

More from Amazon

More options for this calculator

As an Amazon Associate I earn from qualifying purchases.